Skip to content
This page was translated from the Traditional Chinese original and has not yet been reviewed by a person. If anything is unclear, the Chinese version is authoritative.

Viewing: HTML | Download the full feature guide as PDF

Tcon firmware update ​

Navigation: Settings → System → Tcon Firmware (the page title is "Tcon Firmware Management")

Tcon is the panel's driver control board. It converts images into signals the panel can display. Tcon firmware and software update are two different things:

Tcon firmwareSoftware update (OTA)
What it updatesPanel driver boardManagement program and management interface
File format.bin.tar.gz
When it's neededOnly when the manufacturer tells you toWhen a new version is available

Update only when the manufacturer tells you to

Tcon firmware is closely tied to the panel model. The wrong firmware can stop the panel from displaying properly. Update only when the manufacturer or technical support tells you to, and use the file they provide.

Check the current version ​

When you open the page, the "Version Number" is read and shown automatically.

The "Tcon Firmware Management" page: the version number at the top, "Select Firmware File (.bin)" below

ShownMeaning
Version NumberThe current Tcon firmware version
UnknownThe version information can't be read
Read FailedAn error occurred while reading (along with "Failed to read firmware version")

The current version is also shown as "Tcon Firmware Version" in Device info.

Update steps ​

  1. Write down the current firmware version.
  2. In the "Firmware Update" row, tap Select Firmware File (.bin) and choose the file provided by the manufacturer.
    • If the file isn't a .bin file, you'll see "Only .bin firmware files are accepted".
  3. In the confirmation window "Confirm Firmware Update: About to upload firmware file: file name", with the red reminder "Do not interrupt power or operate the device during the update", tap Confirm Update.
  4. "Updating firmware, please wait..." appears. This takes about 2–5 minutes.
  5. On success you'll see "Firmware update successful" and the version number is read again; on failure you'll see the reason or "Firmware update failed".
  6. After the update, go to the image display page and display an image to check that the panel works properly.

During the update

  • Don't cut the power or close the page.
  • Don't display images, clear the screen, or do anything similar.
  • The update takes at most about 5 minutes.

After the update ​

  • The available refresh modes depend on the panel model (Tcon firmware version). The device reads the panel model again right after the update. See Scan direction and refresh mode.
  • If the panel displays incorrectly after the update, contact technical support right away and provide the version numbers from before and after the update.

Notes ​

The page says: "Ensure the firmware file is in .bin format. The update takes about 2–5 minutes; do not cut power. If the update fails the panel may not display anything; please contact technical support." After updating, always check the actual image on the panel instead of relying only on the "update successful" message.

Related sections: Device info and monitoring, Scan direction and refresh mode

Green Ideas Technology